Difference between revisions of "3D milling"

From Splatspace
Jump to: navigation, search
(Introduction)
 
Line 2: Line 2:
  
 
Technological advances are steadily bringing 3D CNC milling into the realm of the hobbyist / maker / DIY / hacker community.  A SplatSpace member is currently working on building one of the latest DIY Mills:  a [http://makeyourbot.org/mantis9-1 Mantis 9.1 Mill].  If this is as successful as we're all hoping it will be, it will probably prove to be a wildly popular and useful project.
 
Technological advances are steadily bringing 3D CNC milling into the realm of the hobbyist / maker / DIY / hacker community.  A SplatSpace member is currently working on building one of the latest DIY Mills:  a [http://makeyourbot.org/mantis9-1 Mantis 9.1 Mill].  If this is as successful as we're all hoping it will be, it will probably prove to be a wildly popular and useful project.
 +
 +
Update: My Mantis 9.1 was finished some time ago, and I have successfully used it to mill PCB boards and to etch designs onto glass.
 +
 +
Work to be done:
 +
 +
1. Work out a better toolchain for KiCAD/Fritzing to Gcode. There is a plugin for Eagle to generate Gcode, but I would prefer something open-source.
 +
 +
2. Ongoing- work on cheapening the design and making it more accessible- if possible make it fab-able by someone with only a bandsaw and drill press.
 +
 +
3. Use a 1/8" end mill to mill out the Mantis' bed and make it truly flat. (endmill is on order)  -JSC
  
 
== Resources ==
 
== Resources ==

Latest revision as of 14:52, 19 April 2012

Introduction

Technological advances are steadily bringing 3D CNC milling into the realm of the hobbyist / maker / DIY / hacker community. A SplatSpace member is currently working on building one of the latest DIY Mills: a Mantis 9.1 Mill. If this is as successful as we're all hoping it will be, it will probably prove to be a wildly popular and useful project.

Update: My Mantis 9.1 was finished some time ago, and I have successfully used it to mill PCB boards and to etch designs onto glass.

Work to be done:

1. Work out a better toolchain for KiCAD/Fritzing to Gcode. There is a plugin for Eagle to generate Gcode, but I would prefer something open-source.

2. Ongoing- work on cheapening the design and making it more accessible- if possible make it fab-able by someone with only a bandsaw and drill press.

3. Use a 1/8" end mill to mill out the Mantis' bed and make it truly flat. (endmill is on order) -JSC

Resources

There is quite a bit of info "out there" on building DIY CNC mills:


See Also