The piratebox is a self-contained provider of an anonymous file sharing and chat network.
We began trying to build one in October of 2011, with the intent to create several pirateboxes for the space.
As of June 2012, we have successfully created one piratebox.
- Jeff Crews
- Darren Boss
There is currently one functioning piratebox in the space, nicknamed V1. It currently requires access to wall power. It is based off the plug version of the piratebox presented at David Darts wiki.
It will be mounted and permanently installed in the space shortly.
- Build began with a pogoplug provided by Jeff Crews and a DD-WRT flashed Linksys router provided by Darren Boss.
- Pogoplug appeared to be unsuitable for use, as the piratebox software provided by David Darts made assumptions about the hardware platform.
- A Dockstar was obtained by j.c.sackett; this was the target platform for the software. It continued to fail, apparently because of differences in the hardware.
- j.c.sackett and Jeff Crews decide to look into better software. j.c.sackett starts trying to isolate the software that actually matters, as it turns out the majority of the provided software is just a debian image.
- j.c.sackett has partial success with getting an older version of the piratebox software to run; life intervenes, the project is on hold.
- The dockstar is bricked!
- j.c.sackett discovers the piratebox software provided by David Darts has been updated to address all the problems found in it so far.
- Using the original pogoplug, V1 is completed for the Makerfaire.
- Post-makerfaire, Drew begins modifying it to work off battery power.
- A possible fix for the bricked dockstar is found.
For maximal awesome, our Pirate Boxes need be tethered to a wall. To that end, the original pirate box used an expensive battery pack to this happen. This offends my ( Drew's ) sensibilities by being really darned expensive.
So the obvious solution is to build a battery pack to provide power. This also provides an excuse to learn about DC power conversion.
The router runs at 12VDC, at 500mA. The pogoplug takes straight AC, however the power supply board says it runs at 5V. This random pogoplug forum post implies that the device runs at <5W, so 1A is needed.
If we can restore the dockstar, we have the parts for a second build. At which point we could start talking about the Pirate Network.
Jeff has proposed building a nicer case, possibly something laser cut, for the box.