Reprap Visit

From Splatspace
Revision as of 14:16, 12 July 2011 by Mike (Talk | contribs)

Jump to: navigation, search
RepRap Visit Prusa Mendel.jpg




Splat Space is working on getting a 3D printer! W00t! The first step is that we are borrowing one from Neil Underwood of Fablocker (the Winston-Salem hackerspace). This came about through a series of discussions that culminated in Alan and Neil talking at the Maker Faire NC 2011 and working out the details.

The specific type of RepRap is a Prusa Mendel. Here's a cool video overview of both 3D printing and Mendel operation: OhmEye's Introduction and Orientation for 3D Printing with the Reprap Prusa Mendel.

Neil says the Prusa is one of the simplest designs, straightforward to build and maintain, and pretty robust. It's also one of the cheapest in parts and effort to build. For about $400 in parts, we could have one. Once we had one built, we could use it to print parts for more.

The Prusa that Neil loaned to us arrived in not-quite-working condition, although he has used it to successfully print in the past. So the first steps are to get it working. See #Current State section for the current state of the printer and #Day by Day section for the details of the debugging effort.

Email Threads

There have been a few e-mail threads about getting and setting up the RepRap. They are archived on the Splat Space Googlegroup:

Prusa Mendel 3d printer for space
Reprap contest?
Prusa: The Arrival

Current State

Machine works mechanically. Firmware needs to be altered to reflect our data with regards to feed volume. Then we can start printing. Drew 17:31, 11 July 2011 (MDT)

Day by Day

Saturday 9th

Team: Alan, Drew, Skippy, and the other Jeff (add yourself as appropriate)

Sunday 10th

Team: Drew, Skippy, Mike, Lisa, Jeff

Problem: extruder not consistently extruding plastic; plastic getting stuck and gouged out by the knurled feed bolt.

Phone call to Neil Underwood.

Took apart extruder assembly and hot end, melted out plastic. (Expected to find glob of PLA from the day before. Only found ABS from today.)

Noticed that skate wheel in extruder was not mounted on an axle and was not turning. Cut off a section of smooth rod to use as an axle, took apart extruder assembly, mounted skate wheel on axle, put it all back together. Wheel turns freely now.

Flossed the teeth of the extruder knurled bolt. It was gummed up with PLA from yesterday and ABS from today. Used Jeff's dental tools for the flossing.

Changed feed rate from 300mm/min to 100mm/min. With the freely-turning skate wheel and a rate of 100mm/min, can get plastic feeding through the extruder consistently. Feed rate is about 5% off from what the software thinks it is feeding. This needs to be updated in the software.

Set the X,Y,Z limit switches again. Re-leveled the build platform (and marked the location of the feet on the table since the table is not level).

Details of the debugging session are captured at Reprap_Visit_Sunday_10th_Details.

Tweeted picture from the debugging session.

Mike 07:37, 12 July 2011 (MDT)

Monday 11th

Team: Drew

After an email exchange with Neil today found out that the length fed into the machine is based on a volume calculation done in the firmware. This was not my understanding of the machine's operation. We need to get a copy of the firmware on the machine, update it per on of the following.

Also there's an IRC channel on freenode, #reprap. I'm told that they're helpful. Drew 17:31, 11 July 2011 (MDT)

Tuesday 12th